In the use and daily maintenance, we should pay attention to the following points, to extend North Ben V3 accessories direction machine service life:
1 in the bumpy road, slow down, reduce steering machine under load.
2 check the protective sleeve on both sides of the direction machine and the protective sleeve of the upper part of the direction machine and the North rush V3 fittings universal cross shaft. Damage of sheath is the most important factor leading to early wear and damage of directional machine. The sheath is damaged, water and sand dust through broken into the steering gear, the lubricant film failure gear rack, lead to machine internal corrosion, abnormal wear phenomenon, if not immediately dispose of the water and sand, in the short term will cause scrap machine direction. So at least once a month to check the state of the dust jacket, such as found damaged jacket must be replaced immediately, and before the replacement of the direction of the machine to do a comprehensive inspection and maintenance.
3 before making the four wheel positioning adjustment beam, change the steering rod, pay special attention to the protective sleeve can not appear distortion, assembly is not in place and other phenomena, otherwise it will cause damage to the sheath.
4 due to the use of grease will gradually become dirty, deterioration, so that lubrication capacity decline; at the same time the wear of the material will gradually increase, abrasive wear phenomenon will become more and more heavy, so that the direction of machine wear intensifies. Every 100 thousand kilometers around the steering machine to do a comprehensive maintenance, comprehensive cleaning, re filling grease.
5 direction machine use conditions harsh, bear the load, must use special grease, ordinary grease can not reach the use requirements.
6 direction machine will gradually increase in the use of the gap, if North Benz V3 parts steering wheel about air travel more than 15 degrees, must be checked on the machine direction, such as abnormal wear of gear rack, steering assembly must be replaced; if there is no abnormal wear, but the gap is too large, can be adjusted. In the adjustment to the service station by trained professionals, adjusted to ensure that the steering wheel can be left, right hit the limit position, and uniform strength, flexible rotation.
7 do not arbitrarily in the equipment simple, low technology level roadside shop direction machine maintenance and maintenance. Steering machine, such as improper adjustment, will cause stuck phenomenon, endangering driving and personal safety.