Baotou North Benz accessories tell you to remember several key points when driving: refuel slowly, control the throttle opening and closing at about 30%, and do not coast in neutral gear. Before shifting up, slowly increase the speed and keep it above 1250 after shifting!

On the premise that the vehicle has no fault, regardless of whether it is a national highway or an expressway or a climbing section, it is necessary to adjust the rationality of the use of speed, understand and guide: power=torque × Speed, understand the power curve of the engine, and let the engine break out at a reasonable torque point to achieve good fuel economy. A driver is concerned about several speeds:

1. Common speed: the standard load is about 1200. For heavy load, it is necessary to increase the speed by 1300~1500 according to the size of the load capacity. With a low engine torque outbreak point, it can provide a large driving force, that is, the so-called throttle opening is reduced, and the economic advantage of fuel consumption is obvious!

2. The speed adjustment before shifting is based on the principle that the engine speed after shifting is above 1250 rpm;

3. The climbing speed is between 1500 and 1700, so that the engine power can play a better role

4. The common economical and fuel saving speed is 60 on the bottom road and 80 on the high road

Inner Mongolia Beiben heavy truck accessories give you some suggestions for Caryou brothers with high fuel consumption:

For vehicles that have been used for more than one year for a long time by vehicles other than PetroChina, please fill up the regular petrochemical oil for 3-5 times and then add 3-4 pints of fuel to brush the engine for carbon! Go to the regular service station, check the diesel filter and clean the oil nozzle!

In a word, the more important point is that no matter whether you are running on a national highway or a provincial highway, you don't need to talk about it. As long as you can reasonably use constant speed cruising, your fuel consumption will be reduced to a relatively low level

Inner Mongolia Beiben heavy truck parts told everyone that every driver could not step on the parts of Beiben when driving. Only by using a reasonable constant speed cruise to stabilize its computer program for a period of time, there was also a major concern about stable fuel consumption (computer control is more accurate than stepping on the accelerator)

High fuel consumption is caused by various reasons. To put it simply, there are two easy to understand reasons: (1) wind resistance. For the same tonnage, it is different to install 4 meters high or 1 meter high. (2) The speed is different between (60) and (80) miles on the road, and between (80) and (100) miles on the highway. (3) It is important to use cruise control reasonably.

Follow the above operation. If your speed ratio is (16 over 3.7/12 over 4.11), your economic speed is 1250 rpm, 75-85 km. You can also follow this operation when the (bottom road) road condition is stable, the accelerator is stable, and the speed is 65 mph. Observe the instantaneous fuel consumption. After running 100 km to lower the fuel, you can drive at will!

*Disclaimer: The reprinted content comes from the network. If you have any objection, please contact us in time. The Baotou North Benz accessories website will be deleted.