1、 Oil

Measurement method and conditions:

1. Drive the vehicle to a horizontal plane

2. Beiben V3 accessory engine reaches the operating temperature, and the oil temperature is not lower than 60 ℃

3. If it is a turbocharged vehicle, it is recommended to idle for 2 minutes first when the temperature is high after intense driving

4. Turn off the engine

5. Check the high oil level within 2 minutes after the engine is shut down

Spend a lot of money on car maintenance. It's better to check these four fluids frequently

One type of left oil dipstick has 11 notches: the low mark min of the oil level Z is at the fifth notch; The high mark max of the oil level Z is at the 8th notch; Each notch is approximately equal to 0.3 liters.

The other right oil dipstick has a MIN mark and a MAX mark; The difference between these two marks is about 1L of engine oil;

Inspection of vehicle oil without oil dipstick:

Tool used: t40178

2、 Coolant

When the engine is cold, check the coolant level;

Pre sales inspection: the coolant level should be at the upper limit (max);

Routine maintenance: the coolant level should be between the lower limit (min) and the upper limit (max); If the coolant level is too low, add an appropriate amount of coolant.

Spend a lot of money on the maintenance of beiben V3 parts. It's better to check these four fluids regularly

Here comes the question! Can ordinary water be used instead of coolant?

The engine cooling system must be filled with a mixture of distilled water, radiator antifreeze and preservative. Even if it is used in hot seasons or tropical countries, it is not allowed to use water to replace the engine coolant; The antifreeze ability of the coolant must be guaranteed to be below – 25 ℃. When it is used in cold seasons or regions, the antifreeze ability of the coolant should be enhanced.

3、 Power steering oil

Beiben V3 accessory power steering oil measurement conditions:

1. Stop the engine and align the front wheels.

2. The engine oil is cold (about 20 ° C or 80 ° C).

3. Screw off the cover.

4. Wipe the dipstick with a clean rag.

5. Screw the cap tightly by hand and then unscrew it to read the dipstick.

I spend a lot of money on car maintenance. It's better to check these four fluids regularly

4、 Brake fluid

be careful:

1. The brake fluid is toxic

2. The brake fluid is hygroscopic

3. Brake fluid inspection

4. Pre delivery inspection: MAX

5. Routine maintenance and inspection: if the friction plate is far from the wear limit, the brake fluid should be between MIN and MAX; When it is about to reach the wear limit and the fluid level is at the MIN (Z low) mark or slightly higher, it is unnecessary to add brake fluid.

Spend a lot of money on car maintenance. It's better to check these four fluids frequently

Having said so much, I wonder if you will check the oil problem?

*Disclaimer: the reproduced content is from the Internet. If you have any objection, please contact us in time. This website will be deleted.