The correct use of the clutch

1) separation is fast and thorough, and grasp the fast slow fast rhythm.

When you step on the pedal, you must step on the bottom. When the loose pedal has just started the distance between the clutch and the flywheel, it can be loosened at this time. When the flywheel contacts with the clutch, it is necessary to slow down the speed and let the torque increase gradually. When the clutch disc is synchronized with the flywheel, the clutch pedal is loosened quickly.

2) often check the pipeline of the clutch hydraulic transmission mechanism

3) to minimize the time of the half linkage state of the clutch

4) mastering the time for a good shift

5) don't build your left foot on the clutch.

Transmission gear shift method

1) stepping on and off, loosing the throttle, almost at the same time

When you shift gears, if you loose the throttle first and then step on the clutch, you will feel an obvious "setback" feeling. Therefore, when you loose the throttle, step on the clutch and shift gears.

2) a little pause for a half off.

3) lift the clutch to press the throttle slightly and properly add some oil.

4) grasp the timing of shift

The timing of shifting is mainly based on the maximum speed of the design of the specific vehicle.

2. The shifting process is recommended according to the engine speed of Baotou Bei Ben heavy truck fittings.

Third, when the low grade is changed to high grade, it is recommended to add 2500 shifts.

A situation requiring four rounds of positioning

After driving 10000 kilometers or six months, the car needs to hold the steering wheel in a straight line when it runs straight to the left or right, feeling that the body will float or swing and install a new tire.

Use of tires

1) the tire pressure on the high speed road is a little higher than the normal value.

2) the tire pressure should be slightly higher when driving in the rainy day

3) the treatment of blowout

There are many reasons for the tire burst of Baotou Bei Ben heavy truck fittings, mainly due to deterioration of tire performance. It is not easy to find a tire before it explode in a car. Only when there is a blasting noise in the running, can it be found when the tire is running off. The front wheel burst tends to drift sharply, and the higher the speed, the greater the risk.

The pressure is not enough to break the side wall of the heavy truck parts of the north of Baotou. When the pressure is too high or the car is overloaded, it can also make the tires blowout, such as the damaged parts of the former. In the hot summer or long time, this kind of feeling is much more common; some other blowouts are in the course of driving. Caused by sharp stones and other objects piercing tires.

Do not panic if the tire burst suddenly during driving. As long as both hands hold the steering wheel, you can still control the car. While watching the vehicle behind, slowly braking and leaving the main road. Do not emergency brake after tire burst, so as not to cause the vehicle to flick or turn over because of uneven braking force.

Water temperature meter

The thermometer on the dashboard indicates the temperature of the coolant.

When the vehicle starts, the indication value is low.