CLASSIFICATION
NORTH-BENZ-BRAND
CONTACT-US
- Name: Baotou beiben Trading Co.,
- Mobile phone: 13327188003
- Mobile:13664067905
- Tel: 0472-3610990
- FAX: 0472-3610990
- Q Q:350013459
- E-mail:350013459@qq.com
1) fault phenomena
In the middle of the car, there is noise in the middle and rear axles, especially when the speed is drastically changed. When abnormal sound occurs, attention should be paid to its characteristics so as to diagnose it.
(1) when the car runs, the rear axle sends out continuous abnormal sound, or there is no rhythm impact sound, and the sound increases with the speed of the car; at the beginning, you can hear the "just" sound behind.
(2) when the car runs, the rear axle gives out rhythmic abnormal sound, and the sound increases with the increase of the vehicle speed, especially in the oil gate or the throttle, and the rear axle has swing phenomenon in severe cases.
When the vehicle runs at high speed (approaching 60km/h) and the throttle is closed, the abnormal noise occurs at the rear axle, and there is a phenomenon of shaking at the rear axle.
Drive axle abnormal fault, not only the noise in the gear parts wear intensifies, and seriously affect the normal running of the vehicle, so the traffic should be paid attention to in the examination, listen to, find fault and remove.
2) cause of failure
(1) the backlash of the gears in the drive axle is too small or too large, the tooth gap is uneven or the assembly is not proper.
The improper adjustment of gears and bearings of the Benz parts in northern Baotou and the holes of the bearing housings are not concentric.
Gear broken or bearing damage.
Bending deformation of half shaft tube.
3) analysis and diagnosis
Parking noise should be checked in case of continuous abnormal noise. Touch the rear axle housing by hand, the fever is not too small; if the fever is serious, generally lack of oil, should check the oil level. Adjust the gear gap or add lubricating oil according to the situation.
If there is an impact sound in the train, the backlash is usually too large.
If the speed of the car is louder, the sound will decrease or disappear when sliding, which is usually caused by the wear of the bearings or the backlash of the teeth. If the speed is changed rapidly or there is abnormal sound on the uphill, the backlash is too large. The bearing should be replaced or adjusted according to the situation.
4. When the car is turning, there is abnormal sound. When the speed is low, it also has the sound, but the speed rises, that is, the northern Baotou Benz parts transmission planetary gear meshing clearance is too large, or half shaft gear and keyway wear.
When the speed is close to 60km/h, loosen the throttle. If there is abnormal sound at the rear axle and shake phenomenon, it will be the deformation of the half shaft bushing, so it should be corrected and repaired.
If the traffic in the Baotou North Benz accessories after the bridge suddenly sounded, for the gear tooth damage, should immediately stop check, otherwise it will seriously damaged gear.