The truck often appears in some small fault, if the timely detection of problems, you can avoid the replacement of parts, or even into the factory maintenance, today summarizes some simple inspection methods and daily maintenance tips for everyone to learn.

Engine oil test

Park the vehicle on a horizontal road surface. Pull out ruler to check the amount of oil, oily in (F) and (L) within the two markings, belongs to the normal range, if less than one (L). The oil of the specified type shall be added, and the liquid level after refueling shall not be higher than (F).

Engine coolant level check

Baotou beiben heavy truck engine parts in engine state, do not open the radiator cap, otherwise you may be cooling liquid or steam burn out. After the cooling of the engine, check the coolant level should be between the full and low, or should add distilled water or pure water (can not add mineral water) or frozen liquid, water after the liquid height can not be more than full. If the cooling fluid is found to decrease rapidly in a short period of time, check that the cooling system is leaking or check at the service station.

Brake fluid level check

Braking is also between high and low, which means normal. If the brake fluid is close to the lower limit or lower than the lower limit, it means that the system may leak or brake shoes wear too much, should be in time to the maintenance station for maintenance. When adding brake fluid, we should pay attention to the same type of brake fluid, prevent damage to the leather bowl, pay attention to protect the paint, prevent corrosion paint.

Check the fluid level of the clutch master cylinder

Clutch fluid level between high and low liquid level is normal, if less than the standard line, it may be Baotou North rush truck accessories, main pump or sub pump leather bowl damage. In the engine running condition, it will appear difficult or unable to hang up the gear. Please check it to the nearest service station immediately.

Battery maintenance check

Check whether the battery is firm, the electrolyte should be between the upper and lower limit, close to the assembly line, should be in time to add electrolyte or distilled water to the high line. Keep the battery positive and negative cable in good contact, and keep the battery clean and dry. When the vehicle is placed longer, the positive and negative cable of the battery should be removed. The engine should be connected again for about half a month, and the engine should be started in about 20 minutes. If the amount of electricity is obviously insufficient, the battery should be charged in time.

Tyre inspection

The tire pressure should be checked at room temperature every month. If the tire pressure is lower than the normal standard, the tire pressure should be added in time. Air pressure can not be too high or too low, otherwise it will affect the safety of driving. Check the cracking of the tire, when there is a hidden danger, you should change the tyre in time. Selection of tyres shall be consistent with the model.

Inspection of belt

When starting the engine or driving the vehicle at ordinary times, the belt is noisy. In one case, the belt is not checked and adjusted for a long time, and can be adjusted according to the normal standard. Another case is the belt aging, need to change.

Inspection of air cleaner

Dirty air filter will cause the engine working poor, fuel consumption is too large, damage to the engine, check the Baotou beiben heavy truck parts air filter, if found less dust, blocking the light, use the high pressure air from the inside out blowing, continue to use. The dirty air filter should be replaced in time.

Inspection of spark plugs

The normal spark plug insulation ceramic is intact. There is no breakdown and leakage. When the spark gap 0.8+-0.0mm discharges, the spark is blue and stronger. If abnormal is found, adjust the gap or replace the spark plug.

Inspection of gasoline filter

If it is found that the oil supply is not smooth, the oil filter should be checked for obstruction, such as foreign body congestion should be replaced in time.