Baotou North Mercedes-Benz accessories clutch driven plate in addition to friction plate damage what damage?

Driven plate and warping deformation, steel and disk hub rivets loose, disk hub spline sets of key teeth wear and other damage. The traction of the driven plate is usually caused by the long slip of the clutch. After the warp deformation of the driven plate in the rotation will produce deflection, so that the North Baotou Mercedes-Benz accessories clutch when the shaking and uneven wear, serious will make the North Baotou Mercedes-Benz accessories clutch separation is not complete. The amount of warp deformation of the driven plate is usually checked with a dial gauge, expressed by the amount of end runout. When the end of the beating more than the allowable value, you can use a special wrench clamp a Jue, or a special folder to clamp its driven plate on the vise correction. Driven plate between the steel plate and the hub is loosened by the riveting is not strong, or the two rivet hole size is inconsistent or different shaft caused by the use of percussion method can be checked, if loose and re-riveting or replace the North Mercedes-Benz accessories Driven plate. The wear of the spline sets of key teeth is caused by sliding friction with the clutch shaft spline teeth. If the friction is too large, it will cause the clutch to start or the speed suddenly changes. Check, the drive plate can be set in the standard clutch shaft spline teeth, or installed in the old spline shaft of the damaged parts, and then turn the drive plate inspection, the request can not have obvious open momentum. Can also be used to measure the width of the hatch tooth gauge caliper to check the requirements of wear and tear does not exceed 0.25mm. Spline tooth wear more than the provisions, should be new products