1, try to choose the manufacturer specified or advanced synthetic oil

Oil lubrication and cooling two roles, it is good or bad affect the bearing life, and thus largely determine the life of the supercharger. Therefore, according to their own engine performance and the actual adjustment of the situation, combined with the local climate temperature conditions, select the appropriate oil label and viscosity level; and gasoline engine and diesel engine machine should be used in principle; generally recommended not to choose, Condition as much as possible to choose the manufacturer specified or in the high-level synthetic oil.

2, start the beginning to low-speed operation of a small increase in speed.

Just start, because the oil pressure is low, take some time to reach the bearing, so the need for low-speed operation at this time, so that high-speed operation before the bearings can be fully lubricated.

3, idle operation not too long

Idle speed, the North Ben v3 accessories engine speed is low, the supercharger speed is very low, the turbine and the compressor gas pressure is lower than the pressure inside the bearing, there will be oil to both ends of the compressor and turbine leakage phenomenon, the bearing was not To the corresponding lubrication and cooling, while oil leakage into the compressor may enter the cylinder to affect the normal work of the engine, so do not idle time is too long.

4, the engine after a heavy load operation, first down to low speed and then slowly turn off.

After the high-speed high-speed operation of the engine, the turbine inlet temperature is very high, the maximum can reach 900 ℃, if the engine is stopped immediately, the oil supply will immediately stop, and the turbocharger rotor due to inertia to continue high-speed Operation, North Ben v3 accessories supercharger internal retention of the oil will overheat, resulting in damage to the bearing and the shaft, so be sure to wait until the low speed after the slow flame.

5, try to use the original model of the supercharger

If the need to replace the pressurized destruction, be sure to specify the maintenance location as much as possible to use the original model of the supercharger. Because each engine with a different supercharger to match the effect is very different, the original manufacturer of the supercharger is the best.

6, the new supercharger before adding a certain amount of oil to be added

Newly installed and used unused turbocharger, before starting to add some oil from the inlet, or turn off the engine throttle to start the motor drive machine running several times, wait for the oil to reach the bearing lubrication surface Officially launched.