Automotive steering system often occurs in a variety of faults, here are some common troubleshooting methods:
The common faults of automobile steering system are as follows: the steering wheel is too large, the operation is not stable, the front wheel is swinging, the deviation is heavy.
Baotou North Benz parts steering wheel transfer is too large, the steering wheel of the ball, the main pin and bushing, wheel bearings, such as wear and tear, such as wear serious or gap overrun, should adjust the repair. If there is no excessive wear or gap, they should check: first, steering worm gear wear, or the required space, such as the gap is too large to be adjusted; second, steering device connected part of the wear and tear, or whether or not to adjust too loose; third, the steering is loose parts installed; fourth. Steering arm loose.
To check the north of Baotou Benz parts wheel dynamic balancing tire assembly is correct, check whether the tire wear uniform; check whether the balance block assembly is correct.
Should check whether the wheel rim deformation; wheel has a horizontal deflection or radial swing; Baotou Benz accessories shock absorber has loose or worn; the horizontal and vertical steering rod ball joint, or has loose steering gear assembly; spring steel U – Bolts, center clamping bolts are loose or damaged; after the dip is the correct tire pressure is correct.
In addition to the high head inspection project content, especially to check on the top: the tire pressure is correct; knuckle bearing has loose; the horizontal and vertical steering rod ball joint has loose; steering assembly is loose; U bolt, spring center plate clamping bolt is loose or the spring plate is damaged; residual deformation. 3, the car pulls when the vehicle is running deviation, can check the following items: the tyre pressure is equal or tire diameter are equal; the wheel bearing is side tightly; the spring plate is on both sides of elastic or uneven deformation; before the beam is correct, the camber is equal; steering knuckle arm, steering knuckle is not bent or deformed after; axle shaft tubes are bent on both sides of the wheelbase is equal.