1, blindly remove the engine thermostat
If the engine temperature is high and the blind demolition of the thermostat, coolant can proceed big circulation, can adjust the cooling intensity, it is difficult to ensure the engine working at a suitable temperature, but the engine is often in low temperature condition, resulting in reduction of engine power, speed up wear, increased fuel consumption. If the North Ben V3 parts engine thermostat failure repair or replacement, the engine temperature is too high, it should overhaul the other parts of the cooling system, can not be removed thermostat.
2, engine temperature is not afraid of high low
Some people think that when driving the engine temperature is not afraid of high low. In fact, the engine temperature is low when the harm is also great. Should be in accordance with the instructions specified in the normal temperature of the vehicle, in order to ensure the service life of the engine.
3, pump fan belt tighter the better
The tighter the belt, the better. Belt is too tight will not only make it elongated or broken, shorten the service life of the belt, but also due to excessive tension, resulting in the North Ben V3 parts generator shaft, water pump shaft deformation and bending of the early bearing damage. Automotive engine fan belt tightness should meet the technical requirements.
4, engine idling temperature
With the idle temperature, due to the low speed, beiben V3 accessories oil pump can not quickly be lubricating oil into each lubricating surface, the oil pressure is low, the movement of engine parts under dry friction or semi dry friction condition; low temperature fuel due to poor atomization, the unburned fuel into the crankcase, scouring out of the oil film on the cylinder wall, will accelerate the wear parts. Therefore, the engine starts a few seconds later, the application of fast idle heating, improve engine lubrication conditions.
5, burner for baking oil bottom
Winter burner for baking oil bottom, it will not only make the additives in the oil and chemical changes, loss of the original performance, but also the oil cement, oil bottom deformation, easy to cause fire. The best way is to adapt to the local minimum temperature in winter to adapt to the oil.
The more advanced method is ultrasonic cleaning and spray cleaning, but the most widely used, the most simple way is the physical removal and chemical cleaning method. These two methods can also be used.