When the clutch slipping, the correct fault reason should be analyzed.
(1) the cause of clutch slippage
Baotou North Benz parts driven disc wear excessive wear or rivet exposed;
The clutch spring is too soft or broken;
Clutch pedal free travel too small;
The driven disc friction plate with oil or harden aging;
The engagement of the clutch and flywheel bolt loosening;
The clutch master cylinder oil return hole plug.
(2) troubleshooting sequence and orientation
Check the pedal free travel, if not meet the standard value, should be adjusted;
If the free travel is normal, should remove the clutch cover, check the clutch cover and the flywheel connecting bolts is loose, if loose, should be tightened;
Look at the Baotou North Benz clutch friction plate edge parts whether there is oil thrown out, such as the oil should be removed by gasoline or alkaline cleaning and drying, and then find out the pollution sources and to exclude;
If found serious wear and friction, aging hardening, exposed rivets and burning oil soaked until the new film, should be replaced, the replacement of friction discs without any crack or damage, rivet depth should meet the requirements;
The inspection of Baotou Benz accessories clutch pump oil return hole, such as the oil return hole plug should be clear;
After the inspection, such as the adjustment of repair, failed to remove the fault, it will decompose the clutch, check pressure plate spring. The pressure plate spring is good, should be the same length, such as uneven, should be replaced with new products, such as elastic slightly reduced, little difference in length can be adjusted in the following spring and washer.